Sometimes the thicker the liquid, the faster it flows.

It's well known that highly viscous liquids (like honey) flow slower than low-viscosity liquids (like water). Now, researchers have been surprised to find that common sense reverses itself when the liquid flows through a chemically coated capillary tube. In fact, when the fluid is 1,000 times more viscous when passing through the capillary, it flows 10 times faster.

The speed at which fluid flows through a pipe is a valuable parameter for extraordinary applications: from industrial processes (e.g. oil refineries) to biological systems (e.g. the human heart).

Traditionally, if a faster flow rate is needed, the pressure can only be increased. However, this technique has its limitations. The pressure cannot exceed the maximum load of the pipe. This is especially true for thin and narrow tubes, such as the microfluidic tubes used to produce drugs and other complex chemicals, so researchers are investigating whether it is possible to increase the speed at which liquids can flow through narrow tubes without increasing the pressure.

In the paper, published October 16 in Science Advances, the researchers found that by coating the inside of the tubes with compounds that repel liquids, they can make viscous liquids flow faster than low-viscosity liquids.

Professor Robin Rath, from the research group at Aalto University's Department of Applied Physics, explained: "The superhydrophobic surface consists of tiny bulges that trap air in the coating, so that droplets that fall on the surface act as if they were on a mat of air."

The superhydrophobic coating itself does not accelerate the flow of liquids of higher viscosity. However, this changes dramatically when the droplets are confined to microfluidic very narrow pipes. The superhydrophobic coating on the pipe wall creates a small air gap between the inner wall and the liquid droplet.